It is among the hardest of natural waxes, being harder than concrete in its pure form. Carnauba is translucent at best with only minimal light reflection.
Only a small portion of your vehicle's shine comes from the wax itself. There is also a hard segment (polymerization) that has high urethane density, which gives the coating hardness and tensile strengthĬarnauba in today's wax formulas functions mostly as a carrier it’s used to keep the polymers and oils on your car's surface. The basic structure of a polyurethane clear coat features a soft segment (polyol or tetramethylene ether) which gives it flexibility and elasticity. A polymer, unlike wax forms a molecular bond with paint once it’s had enough time to cross-linking, usually 12 – 24 hour.Ī unique aspect of polyurethane chemistry is that the hydrogen bonding acts as an additional crosslink, but also allows thermoplastic flow, which helps the paint surface to retain its elasticity and its tensile strength to relieve mechanical stress. before it has cross-linked, the contaminants may interfere with the film, preventing the polymer from achieving its maximum performance and durability. If the coating is exposed to contamination such as oil, rain, water, cleaners, etc. It is very important to allow polymers to cure for 12 hours after the haze has been wiped off. Curing is required to allow the monomers (polymer building blocks) to attach to the surface and to polymerize into a crystal-clear, impervious film. When polymer chains are linked together extensively by chemical cross linking - the formation of covalent bonds between chains the polymer is harder and more difficult to melt. Drying generally refers to evaporation of the solvent or thinner, whereas curing (cross-linking) refers to polymerization of the binder, which imparts adhesion, binds the pigments together, and strongly influences such properties as gloss potential, exterior durability, flexibility, and toughness. Note that drying and curing are two different processes.
This process usually requires 12-24 hours, which are time and temperature and / or humidity dependent. Need a porous surface to bond to, they initially adhere by surface tension and then after a period in which the solvents /oils in the carrier system vaporize (outgas) the polymers cross-link to form a covalent (molecular) bond to the surface. Bear in mind that how a paint surface ‘looks’ is very subjective and tends to invoke an emotional reaction rather than a logical one 95% of an applied wax comprises out gassed solvent that is wiped away, whereas 65% of a polymer sealant that is applied remains.ĭetailers who prepare show cars will often layer a Carnauba wax on top of a synthetic wax the synthetic wax acts as a gloss layer, while the carnauba wax adds depth and a so called wet-look (jetting) appearance Adding a Carnauba wax to the surface provides depth of shine, gloss, jetting (the so called ‘wet look’) and a warmth to the paint surfaces overall look. Some detailers find that a polymer sealant tends have a flat, silvered mirror look.
0 kommentar(er)
